Indoor Cactus Fountains

E-Series Water Sculptures

Install your new e-series water sculpture from Stone Cactus Waterfalls. Depending on where you want your sculpture, there are different ways to install your liner bowls, however, they must always be level. Call us today for more information.

• In-ground setup- direct planting liner should be set to 1" above grade, ideal for indoor use or covered patio areas.
• E-Series comes as a packages that includes your cactus, bowl, rocks, and optics.
• Planted in stone cactus bowl- place lid next to the bowl, plug in all three plugs (pump, optic, and up light) into the three-way plug with the opposite plug out of the chase port.
• Place liner into the bowl level, do not pinch the cords
• Attach the power supply cord, excess cords can be pushed into the chase port

General Setup for E-Series Fountains

• Place the Smart lid evenly onto the liner bowl, with cords between the liner and lid in the back near the access lid
• Fill liner bowl with clean water to the top of the PVC fitting
• Plug in the 12-volt transformer to test- water will flow and lights will come on
• After water and lights are running, place the sculpture onto the plumbing port, while keeping the sculpture straight, and slowly lower it to connect to the lid (not necessary for the sculpture fitting to fully engage with the lid port)
• If the sculpture drops into the lid port and is not straight, lift and twist the sculpture while holding down the lid, reset keeping the sculpture straight
• After the sculpture's water and lights are running, place the cover over the access hole
• Position up light cord around the edge of the lid to your desired spot
• Place small stones to cover the lid after starting up. Choose rock size - penny, nickel, quarter
• Fill the water as needed. The tallest arm will run dry when the water is low. Refill to the top of the PVC fitting. Do not overfill. Never run the system dry- this will damage the pump
• Keep the transformer dry, do not add chemicals, hard water is fine
• A remote control can be added to switch the system to wireless.